40+ Protective Lubricant - COMPLETE MAINTENANCE TREATMENT 400 ml

40+ PROTECTIVE LUBRICANT

COMPLETE MAINTENANCE TREATMENT

Ambersil 40+ is ideal for use on all mechanical and electrical equipment. As a penetrant, it will quickly free seized nuts, bolts and bearings, whilst the highly effective water displacing properties make 40+ the perfect ‘damp-start’ solution for ignition systems and other electrical equipment.

The protective, lubricating film is non-conductive and remains operational even at severe sub-zero temperatures. It will not affect paints or plastics and is lastingly effective on all metals, including aluminium. Freshly machined surfaces resist ‘finger-printing’ and will stay clean and bright, even in highly corrosive conditions.

Fitted with a 360Spray System for all angle use, even upside down.

TECHNICAL DATA

• Appearance: Amber coloured liquid
• Odour: White Spirit
• Specifications/Approvas: Rolls Royce Item 1036J, Approved Supplier 176, Ford Tox No. 114469, Rail Approved – Catalogue No. 027/025030
• SG @ 25°C: 0.79
• Pressure @ 25°C: 5 Bar (aerosol)
• Discharge rate: 1.2g/sec (aerosol)
• Initial boiling point: 147°C
• Temperature range: Operational from –20°C to +115°C
• Moisture content: Less than 700 ppm
• Corrosion protection: 200 hours in BS 3900, F4 Salt Spray Test
• Solubility: Soluble in solvents, insoluble in water
• Film Thickness: 1.65 x 10-4 cm
• Film Weight: 1.46 g/sq. metre
• Flammability: Classified as extremely flammable under CHIP Regulations
• Flashpoint: 43OC for non-aerosol. Not applicable in sealed aerosol.
• Compatibility:

Rubber - No visible affect when sprayed. Most rubbers will swell after prolonged immersion

Paintwork - No affect on surface. Wax polishes and coatings may be softened after prolonged exposure

Plastics - No visible affects after 240 hours immersion of formica, acrylic sheet, polyester glass fibre laminate, epoxy glass fibre laminate, vinyl sheet and ebonite

Over-painting - Although not always necessary, removal of 40+ form surfaces to be painted is recommended

 STORAGE

The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC, away from direct heat and naked flame.

HEALTH AND SAFETY

Health and Safety sheet available separately.

TECHNICAL SERVICE

CRC Industries UK Ltd provides a technical support service and maintains a constant programme of research and development. We are able to assist customers by specific product development to meet particular requirements.

MISREPRESENTATION ACT 1967 TRADE DESCRIPTIONS ACT 1968

The information given in this publication is based on our experience and reports from customers. There are many factors outside our control and knowledge which affect the use and performance of our products and for which reason no warranty is given, express or implied. Users should make their own tests to determine the applicability of such information or the suitability of any products for their own particular purposes. Statements concerning the use of the products described herein are not to be construed as recommending the infringement of any patent and no liability for infringement arising out of any such use is to be assumed.

PRODUCER:

CRC Industries UK Ltd, Wylds Road, Bridgwater, Somerset, TA6 4DD, UK.

Download Technical Data Sheet in PDF :